1/6/2023 0 Comments Stranger things pinballRestore the playfield to normal play position and replace the balls. The ribbon cable should be tucked just behind and under the back playfield glass receiver channel. Notice here, I have roughly marked the length of the lights to know where to clean and positioning of the lights is critical for the best effect and clean factory finished look. The two magnets fight against each other. If polarity it wrong light bars will always shift when you re-attached them and never go in the correct spot. #Stranger things pinball install#If you take them off and install them there is a good chance you will reverse polarity if they are not put on with the light bars. The light bars are to be installed with them on for two important reasons, one for correct positioning and also for polarity of the mounts. Also DO NOT remove the other side of the Magna-Mounts from the light bar prior to installation. This is a VERY IMPORTANT step as this will insure the Pin Stadium lights a solid mount. The wipe is to insure the best adhesion for the Magna-Mount system that hold the lights to the side of the cabinet. It will need to be very clean and completely dry before proceeding. Clean about 2 inches below the glass so not to pick up any stray dust. Positioning of the lights will be 1/8th of an inch below the glass channel. Lower the playfield back down to it’s level resting position and use the included alcohol wipe to clean just below the playfield glass track. This kit is real UV so it’s Very important!! This will make the light bar to get warm and lose bond with the cabinet wall along with causing damage due to the heat. Make sure this connection is solid and firm due to the fact that if these become detached, the UV will stay on and get warm. Be sure to do this with the game “Off” of course. If this is the case, simply get a small flathead screwdriver and back off the factory heat shrink to make room for the clips to grab onto the terminal. Note: In some cases the alligator clips may not be able to reach clip cleanly onto the terminals due to the black heat shrink that is on them from the factory. True UV Reveal Flasher: Connect the other cable to a Purple GI Bulb with the alligator clips (polarity does not matter here either) Once you find it then use the “Y” Konekt adapter(attached to the Red/Green cable) supplied with the kit which will allow you to simply unplug the factory flasher and plug it inline with this flasher. Even easier, you can see the #172 flasher location indicated by the pic below. Be sure to pull out white the high voltage switch buttons located near the hinge of the coin door or the flashers will not work during this Settings mode. You can visually locate this flasher by opening the coin door and going into Settings/Diag/Lamps and cycle to #172 using the volume buttons. UV+Glow: This is the RED/GREEN cable coming from the same USB GI module mentioned above and this will go to the #172 Lower Right trigger which is the flasher on the right side near the ramp. GI: Connect the BLUE/WHITE cable’s alligator clips to a White GI Bulb (polarity is not important so it doesn’t matter which side you connect them to) and plug the other end of this cable into the USB connection on the GI Module(black heat shrink with USB connection). Turn on the “UV Kit Installed” change it to “YES” or this kit WILL NOT work. First going into Settings/ADJ/Feature Adjustments(ST) by opening the coin door and use the buttons to navigate to that menu.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |